zcM1000 Finger Guard


zcM1000P680 Installation Instructions
 

  1. Remove cutting head from tape dispenser
  2. Place finger guard on cutting head so that it sits flat on the outer part of the cutting head and straddles the inner part of the cutting head.
  3. Align the guard so that the top of the guard is even with the top of the inner part of the head.
  4. Mark location of finger guard holes on cutting head and drill 1/16” pilot hole in cutting head.
  5. Insert screws through the two holes in the guard and into the cutting head.

Leave a Reply

Your email address will not be published. Required fields are marked *

Translate »