TDA025 Turn Table Replacement
- Turn unit over and remove 4 screws that hold the top to the base.
- Using hand crank, cycle cutter arm until it is away from the turntable. (Make sure that
the length adjustment is all the way back.) - Remove top from base by pressing down on the tape holder arm and pushing up at an
angle under the turntable directly across from the tape holder arm. - Look into the top and remove screw and lever #7,8,9. (Be careful not to lose spring.)
- Remove #2 screw from inside machine, it will allow the #2 knob to be removed.
- Look at the turntable. Remove two screws #10.
- Part #3 is hooked onto #1 at two places. Using flathead screwdriver, pop #3off of #1.
(When it is popped off, #3-6 will be loose.) - Remove #1 and replace it with new turntable.
- Pop #3 back into #1 with parts arranged as shown. (Make sure that the slotted
extension on #3 is opposite of the on/off switch.) - Reinsert screws #10 and #2 and replace #7 lever.
- Replace top on machine. Use caution not to bend fan blades. Also, the slot on #3 must
be aligned to fit over the spring-loaded arm that is attached to the turntable
adjustment knob. - Replace 4 screws that hold top onto base.