LD5000 Troubleshooting Guide No Power: Make sure unit is plugged in. Turn power switch on. Check fuse (21A). Check electrical connections   Power, No Feeding: Make sure sensor is clear (not “seeing” anything). Move hand across sensor and watch light on backside to make sure sensor is registering presence/absence. Check relay for switching with presence/absence. […]

  LD5100 Troubleshooting Guide No Power: Make sure unit is plugged in. Turn power switch on. Check fuse (21A). Check electrical connections.   Power, No feeding: Make sure sensor path is clear (not “seeing” anything) Move hand across sensor and watch light on backside to make sure sensor is registering presence/absence. Check relay for switching […]

  TDA025 Feed Lever Reset  Turn unit over and remove 4 screws that hold the top to the base. Using hand crank, cycle cutter arm until it is away from the turntable. (Make sure that the length adjustment is all the way back.) Remove top from base by pressing down on the tape holder arm […]

  TDA025 Troubleshooting Guide   No Power: Make sure unit is plugged in Turn power switch on Check fuse (48) Make sure Safety Cover (14) is fully closed   Tape not sticking to carousel: Wipe down Carousel (1) with IPA Tighten screw on Lever (46) to increase length of tape placed on carousel Loosen screw on […]

  TDA080 Troubleshooting Guide No Power: Make sure unit is plugged in Turn power switch on Check fuse Check transformer for 12VDC output Check continuity of switch Plug transformer into known good circuit board   Switch light on, no feed or cut: Remove and reseat circuit board Replace circuit board   Won’t feed / Tape […]

  TDH201 Troubleshooting Not Cutting: Check and clean blades, replace if dull Check for worn or broken lower blade spring Check lower blade adjustment   Not Feeding: Check yoke spring adjustment Check feed gear assembly for missing or flattened teeth Check for missing feed handle pawls Check blades for accumulated grease or tape resins and […]

  zcM1000 Troubleshooting   No Power: Make sure unit is plugged in. Turn power switch on. Check fuse (120). Check transformer (111) for 12VDC output. Check continuity of switch. Must remove cover (101) and internal metal frame (501/502). Plug transformer into known good circuit board (504).   Display Shows “999”: Turn photo sensor switch (560) off. […]

START International Troubleshooting Guides   This page contains a list of troubleshooting guides for our dispensers. Just click on a link below to view the specific troubleshooting guide that you need.    As always, if you have any additional questions, please feel free to CONTACT US.     Tape Dispensers   ZCM1000 Troubleshooting Guide   TDH205 […]