TDA025 Hand Crank Replacement
- Turn unit over and remove 4 screws that hold the top to the base.
- Using hand crank, cycle cutter arm until it is away from the turntable. (Make sure that the length adjustment is all the way back.)
- Remove top from base by pressing down on the tape holder arm and pushing up at an angle under the
turntable directly across from the tape holder arm. - Remove #66 Tape Set Lever. NOTE SPRING LOCATION.
- Remove #62 Gear Cover
- Loosen screws that hold #55 Motor Chassis to #45 Base until #68 Lever can be removed from gear pin.
- Replace #68 Lever and secure #55 Motor Chassis.
- Replace #66 Tape Set Lever making sure to replace the spring correctly.
- Push #66 to most forward position while replacing #62 Gear Cover. Do not allow the #66 Lever to go back to its original position until #62 cover is secure.
- Test Tape Set Lever.
- Replace top on machine. Use caution not to bend fan blades. NOTE: The slot on #3 must be aligned to fit
over the spring-loaded arm that is attached to the turntable adjustment knob. - Replace 4 screws that hold top onto base.